|
|
AS-21 AUDIO SWITCHER |
 PAC AS-21 AUDIO SWITCHER
The AS-21 switches between two audio sources triggered either by a negative or positive power source. Switch between a VCP or DVD, Playstation or DVD or any other combination. Great for head units that only have one auxiliary audio input. The AS-21 uses an isolation IC chip which prevents ground loops, the cause of alternator whine.
|
|
|
|
|
|
|
IR-X IR REMOTE CONTROL EXTENDER |
 The IR-X extends the Infrared signal from any wireless remote to control products that are
hidden or out of the remotes line of sight. No need to modify equipment to extend the internal
remote receiver.
Easy two wire hook up.
Extra long, 17 feet plug-in wire for IR LED.
Red LED for confirmation of operation.
Small and easy to mount.
40 kHz and 56 kHz operation.
9-12 vdc operation.
Recommended Application
VCR, DVD, TV tuners, stereos that are in trunks, glove box, under seats, or equipment just
out of sight of wireless remote.
Great for RV's, marine, custom hot rodders, and many other applications.
note: The IR remote being used must use a 40Khz or 56kHz carrier frequency. Consult with
equipment manufacture to determine the carrier frequency.
|
|
|
|
|
|
|
LC-1 REMOTE LEVEL CONTROL |
 A pre-amp stereo remote level controller. Mountable in dash or under dash. The LC-1 allows you to add subwoofer level controls to any head unit.
The LC-1 remote amplifier level control is used to adjust an amplifier's power level from a dashboard location. If adds subwoofer level controls or balances a multiple amplifier installation. Range is +/- 8db. Mount it in or under dash.
Connect the inputs of the LC-1 to the outputs of the source unit you wish to control (stereo, equalizer or crossover) that was connected to the inputs of the amplifier. Connect the RCA cables from the output of the LC-1 to the inputs of the amplifier.
|
|
|
|
|
|
|
PAC-80 80 AMP RELAY |
 PAC-80 80 AMP RELAY
Allows you to 'really' turn off all power to amplifiers, whole system, light bars, etc. to prevent current leakage and the loss of battery power. Power relays can also be used to isolate multiple batteries to maintain battery life and usage control.Switching may be setup to operate manually or automatically
Durable weatherproof construction.
handles 80 amps continuous and 150 amp surges.
|
|
|
|
|
|
|
SNI-1 PAC RCA FLITER |
 SNI-1 PAC RCA FILITER
RCA noise filter of unparalleled quality. It provides for ground loop isolation and prevents unwanted DC current in your RCA Cables. Its almost perfect response makes the SNI-1 the best RCA noise filter on the market.
|
|
|
|
|
|
|
SNI-15 PAC 10 TO 2 O WATT SPKER/ RCA |
 SNI-15 PAC 10 TO 20 WATT SPKER/ RCA
PAC's line output converters quickly and easily convert factory or aftermarket radio audio output to RCA output converts from 10 to 30 watts per channel with a fixed 10:1 conversion.
(preamp level). This allows the use of amplifiers, equalizers, crossovers and more speakers
Linear from 20-20,000Hz at +/- 5 dB, while maintaining signal phase.
Isolates input and output circuits to prevent ground loop noise.
|
|
|
|
|
|
|
SNI-35 PAC ADJ. SPKER TO RCA |
 SNI-65 PAC ADJ. SPEAKER TO RCAPAC's line output converters quickly and easily convert factory or aftermarket radio audio output to RCA output (preamp level). This allows the use of amplifiers, equalizers, crossovers and more speakers
Linear from 20-20,000Hz at +/- 5 dB, while maintaining signal phase.
Isolates input and output circuits to prevent ground loop noise.
SNI-35 adjusts the signal from 2 to 40 watts per channel. Signals below 20Hz cutoff.
|
|
|
|
|
|
|
SNI-8 PAC 1 TO 9 WATT SPKER /RCA |
 SNI-8 PAC 1-9 WATT SPEAKER/RCA
PAC's line output converters quickly and easily convert factory or aftermarket radio audio output to RCA output (preamp level). This allows the use of amplifiers, equalizers, crossovers and more speakers
Linear from 20-20,000Hz at +/- 5 dB, while maintaining signal phase.
Isolates input and output circuits to prevent ground loop noise.
SNI-8 converts from 2 to 10 watts per channel with a fixed 5:1 conversion.
|
|
|
|
|
|
|
TR-4 REMOTE TURN ON |
 TR-4 REMOTE TURN ON
Senses voltages as low as 0.8 volts and gives you a 12 volt output with a one second delay. Trigger off of speaker leads or +5 volt remote wires.
• Add a remote turn on for aftermarket amplifiers in vehicles without a factory remote wire.
• Eliminates turn on pops in amplifiers.
|
|
|
|
|
|
|
TR-7 UNIVERSAL TRIGGER OUTPUT MODULE |
 THE TR-7 IS A UNIVERSAL TRIGGER OUTPUT THAT HAS SEVERAL USEFUL
TRIGGERING FEATURES PROGRAMMED IN A SINGLE UNIT
1) LOW VOLTAGE REMOTE TURN-ON
2)ALPINE CVA-1600 VIDEO BYPASS
3)DOOR LOCK PULSE GENERATOR
4)LATCH ON/OFF OUTPUTS
5)LINEAR ACTUATOR CONTROL
6)HORN HONK OUTPUT
7)DOUBLE PULSE OUTPUT
8)CHANNEL SPLITTER
9)PULSE EXTENDER
10)CHIRP ELIMINATOR
11)3 CHANNEL DELAYED CONSTANT TRIGGER OR ON/OFF AND
MORE FEATURES. ALL FEATURES ARE SELECTABLE THROUGH EASY
PROGRAMMING STEPS
|
|
|
|
|
|
|
TURBO-1 INCREASES PREAMP LEVEL |
 The Turbo 1 increases the preamp level being delivered to the amplifiers. Increasing pre-amp level signal helps to better balance your system and allows you to get more juice out of your amplifiers.
• S/N ratio of 96 dB for high quality sound.
• Average draw is less than 15 milliamps.
• The Turbo 1 is adjustable from 0.1 to a 15dB increase.
• As many as 10 amps can be driven off one Turbo 1.
|
|
|
|
|
|
|
uPAC-HDRT |
 The uPAC-HDRT receives analog and digital HD Radio stations while providing complete control of AM and FM tuning through the factory radio. The HD Radio digital tuner provides crystal clear static-free AM and FM reception and expanded content with exciting new formats on FM HD2 multicast stations, all with no subscription fees
|
|
|
|
|
